Custom Drawer Box Dividers

Fixed drawer box dividers are used to divide a custom drawer box into vertical and/or horizontal sections. The dividers are mounted inside the drawer box, and glued & pinned to the sides and bottom. Fixed dividers are constructed as follows;

• Dividers are made of the same material and thickness as the drawer box sides.
• The height is custom made to be 1/16” lower than the top of the drawer box.
• When ordering, specify the number of dividers (BD1, BD2, BD3, BD4, BD5, etc.).
• If a custom layout is desired, please supply a drawing

Adjustable drawer box dividers are used to divide a custom drawer box into vertical or horizontal sections. Two (2) rows of 3mm diameter holes are drilled on each side (inside) of the box. The holes are referenced from the center of the drawer box and are drilled in both directions (in increments of 32mm) until they reach 2 to 3-1/4 inches from each inside end. The dividers are slotted on each end so that they can slide on metal pins (provided by SVW). Adjustable dividers are constructed as follows;

• The price is in addition to the fixed divider price.
• Dividers are made of the same material and thickness as the drawer box sides.
• The height is custom made to be 1/16” lower than the top of the drawer box.
• Four (4) metal pins are provided with each divider.
• The minimum box height is 2”.
• If the drawer box height is less than 2-1/2” an additional charge is applied per divider.
• If the drawer box requires custom setups an additional charge is applied per drawer. This would include vert. and hor. dividers in the same drawer box and partial hole drilling in the drawer.
• The box can be constructed with HOLES Only, NO Dividers.